焊接器操作步骤 

 

1.准备工作结束后，打开操作开关，仔细调整工作电流开始焊接。

 

2.因任何原因，电热熔焊机中途停止工作时，计时器都会记下电流通过的时间。按下rst键复 位，重新操作）

 

3.做好准备工作，连接导线—打开电源开关—设定电压档和时间—打开操作开关—计时器开始计时—调整电流到设定值（缓调）开始焊接—达到设定时间，蜂音器响自动断电—关闭操作开关至OFF、电流旋钮回零—摘下连接线夹子—按规定时间冷却—检查—工作结束。

 

4.焊接器会在电压过高或电流过大的情况下自动断电，因此，在判断焊接器是否在正常的数据下工作时，只需关上然后再打开电源，切断装置使系统恢复到正常状态。 

Welding procedure

 

1. After the preparation, turn on the operation switch, carefully adjust the working current and start welding.

 

2. For any reason, when the electric fusion welding machine stops working in the middle of the process, the timer will record the current passing time. Press RST key to reset and operate again)

 

3. Make preparations, connect the wires - turn on the power switch - set the voltage level and time - turn on the operation switch - start the timer - adjust the current to the set value (slow adjustment) and start the welding - when the set time is reached, the buzzer will ring and automatically cut off - turn off the operation switch to off, the current knob returns to zero - remove the connecting clamp - cool down according to the specified time - check - the end of the work.

 

4. The welder will automatically cut off the power when the voltage is too high or the current is too high. Therefore, when judging whether the welder works under normal data, just turn off and then on the power supply, and cut off the device to restore the system to normal state。